100A Relay Board in 0.5 Tesla Magnetic Field for Ukraine

100A Relay Board in 0.5 Tesla Magnetic Field for Ukraine

Simple Info Dimensions(mm) 29×23.5×16
Fat ( g ) ≈40g
Contact Arrangement 1A/1B
Contact Substance AgSnO2
Ambient Temperature -forty~+75ºC
Vibration 10~50Hz,1.5mm
Shock 1000m/s²,(100g)
Technical specs Knowledge Electrical power Use <3W
Functioning Voltage 10.5-16V
Max. Switching Existing 100A
Surge Current 6000A/10ms
Motor Resistance 32(1±15%)Ω
Get in touch with Voltage <60mV
Make contact with Resistance ≤1.0mΩ
Dielectric Strength Motor to Get in touch with >4000VAC,fifty/60Hz 1min
Throughout Open Get in touch with >2000VAC,50/60Hz 1min
CZPTal Lifestyle(one hundred twenty cycles/H) ten,000
(resistance 5 k + perceptual five k, co ϕ = .5)
Mechanical Existence(3600 cycles/H) 100,000
Pulse Time ≥60ms(Recommend 60ms~100ms)
Finding-up Time ≤60ms
Release Time ≤60ms
Insulation Resistance >1000MΩ(500VDC)

           Cautions of Latching Relay:

             1.Recommendations of relay’s enter
            (1)Polarity-Remember to examine the polarity inside of of our technical specification, if solitary coil then”+ -” or “- +”are fantastic,

            you can modify it by a single pulse.If double coil then it’s required to validate “-+-” or “+-+”prior to leaving the our manufacturing unit.

            (2)Driving-Please energize the relay at our suggest pulse width, rated voltage for trustworthy performance, if one.5

            occasions or two occasions of value or lower driving situation plz verify with our engineer.
            (three)Relays’contact status may possibly be changed in the course of transportation or set up owing to effect of external power,
            therefore please reset to the necessary position.

 

            2.Ideas of relay’s output
            (one)When picking the relay with challenging link,you should stay away from the exterior drive on load terminals in the course of or after

            the installation.

            (two)When the relay will be related with screw or bolts to the relays’ terminals, plz make confident your link is

            fastened and stop relay from damages or other basic safety difficulties due to temp. Increase..

            (3)The sampling sign wires of goods are restricted, make sure you do not pull or torque for the duration of installation.

100A Relay Board in 0.5 Tesla Magnetic Field for Ukraine