| Basic Knowledge | Dimension(mm) | 32×35.5×16.5 | |
| Weight ( g ) | ≈35g | ||
| Get in touch with Arrangement | 1A/1B | ||
| Speak to Materials | AgSnO2 | ||
| Ambient Temperature | -forty five~+85ºC | ||
| Vibration | 10~50Hz,.075mm | ||
| Shock | 1000m/s²,(100g) | ||
| Specification Data | Nominal Voltage | 9~36VDC | |
| Electricity Consumption | <1.5W | ||
| Working Voltage | seven.2V | ||
| Max. Motor Voltage | 36V | ||
| Max. Switching Existing | 90A | ||
| Surge Current | 2500A/10ms | ||
| Motor Resistance(R±15%) | 60Ω | ||
| Speak to Voltage | <60mV | ||
| Speak to Resistance | <0.6mΩ | ||
| Dielectric Strength | Motor to Contact | >4000VAC 1min | |
| Across Open Get in touch with | >2000VAC 1min | ||
| CZPTal Lifestyle | >10000cycles | ||
| Mechanical Daily life | >100000cycles | ||
| Pulse Time | 100ms~150ms | ||
| Choosing-up Time | <65ms | ||
| Release Time | <65ms | ||
| Insulation Resistance | >1000MΩ(500VDC) | ||
Cautions of Latching Relay:
1.Ideas of relay’s input
(one)Polarity-Make sure you check out the polarity within of our complex specification, if one coil then”+ -” or “- +”are good,
you can change it by one particular pulse.If double coil then it’s needed to verify “-+-” or “+-+”prior to leaving the our factory.
(2)Driving-Please energize the relay at our suggest pulse width, rated voltage for dependable functionality, if 1.5
moments or 2 times of value or reduced driving issue plz affirm with our engineer.
(3)Relays’contact status may be modified during transportation or installation because of to effect of external pressure,
for that reason please reset to the needed standing.
two.Recommendations of relay’s output
(1)When choosing the relay with challenging link,make sure you stay away from the exterior power on load terminals in the course of or after
the set up.
(two)When the relay will be linked with screw or bolts to the relays’ terminals, plz make certain your link is
mounted and avert relay from damages or other safety problems owing to temp. Rise..
(three)The sampling sign wires of merchandise are limited, please do not pull or torque during set up.
